It's no matter how carefully you use your Samsung washing machine, it may fail one day. Here, you can find the common problems and their solutions associated with your machine. The Samsung washing machine troubleshooting guide will assist you to fix the problems yourself quite easily. This guide may help to keep your machine working smoothly and save money from costly repair.
Samsung Washing Machine Problems Solutions
Get our PartsIPS free tips to troubleshoot your Samsung front load washer problems as well as Samsung top loader washing machine problems.
Door is locked and will not open
Usually, this problem may happen when you are in the mid-cycle. You have to press the start or pause button to stop the unit. The door will remain open during the heating portion of sanitize cycle. It can take some time to disengage. If it doesn't work, then the door switch latch may be bad. You need to replace the Samsung washing machine door latch if required.
Water is not draining or spinning
This issue could be raised for several reasons. Initially, you have to check drain hoses and make sure that they are not blocked or kinked. Moreover, asses the filter that doesn't clog with debris. Clean the debris under the kitchen tap. You should check your manufacturer's manual to get instructions. If the problem with the drain restriction, you need to call an engineer.
Washing machine will not start
Make sure the door is closed properly and should be plugged in. Be sure the water source faucets are on open. Make sure you have to press the start/ pause button. Ensure the child lock isn't activated. If it is activated, press & hold spin and soil level buttons simultaneously for 6 seconds. Before starting to fill the water, the machine will make clicking sounds for checking the door lock and quick drain. Also, check the fuse or reset circuit breaker.
No water or taking enough water
This might be because water source faucets are not turned on or occur when you aren't close the door properly. If any kink or debris blockage in the inlet, then it might stop water from getting in. Moreover, check for hose filter screens blockages. However, you can try opening and closing the door and pressing the start or pause button once.
Machine fills with wrong water temperature
Make sure, you have to open both faucets fully and hoses should connect to the correct faucets. Ensure the temperature selection is right. The temperature you have to set to deliver a minimum of 120°F hot water at the tap. Also, see your hot water tap temperature not too cold or not too hot. Moreover, verify the water heater capacity and recovery rate. The hose filter screens may be clogged so that cleaning the screens on the hoses can help if it stops water from getting through.
Machine leaks water
Make sure to check whether the door is closed correctly or not and hose connections are tight. Inspect where the drain hose is connected into the drainage systems that the end of the hose inserted and fitted. It is the better thing that avoiding overloading and use the right detergent. Sometimes, overloading and wrong detergent which cause foaming will leads to leaking.
At the end of the cycle, wash cycle is excessively wet
Select the wash on high or extra high spin speed to reduce this problem. You should not use very small loads because small loads may become unbalanced and not spin out properly.
Detergent remains in the dispenser after the wash cycle
This may occur with an old detergent that blocks the dispenser. It just needs cleaning. When there is not sufficient water pressure to wash the detergent through, this might appear. Ensure the detergent selector is in the upper position if you are using granular detergent.
Samsung washing machine has excessive vibration and noisy when spinning
Check for your machine is on a level surface. If it is not on the level surface, adjust it carefully. Moreover, the machine should not in touch with other things. Be sure the load is balanced and verify any bolts are removed.
Samsung VRT Washer Troubleshooting
We can found this VRT technology in innovative washing machines only like Samsung. The function of the VRT is so quiet during the appliance's operation. This feature will help with less vibration compared to others. You should keep the dryer drum odor-free and fresh.
There are different error codes for Samsung VRT spin cycle problems such as UE, UL, and DC. These errors will occur when the machine is overloaded and the drum is unable to spin. Check the owner's manual to get troubleshoot solutions for these types of Samsung washing machine problems.
If you want to get any replacement for damaged or broken spare parts of Samsung washing machine, simply find those parts at PartsIPS. We supply you all original Samsung parts for your washing machine. Doorstep delivery is available. Hurry up and buy from us today.
Hope you got the best solutions for your Samsung front load washer problems and Samsung top loader Washing Machine problems repairing. For further queries, leave a comment and we will assist you soon.
About the Author